Floor-Standing Fan Coil Units
Floor-standing fan coil units provide hydronic room heating and cooling where concealed ceiling installation is unavailable or convenient service access is required. Midea MKH2 units are positioned at low level, commonly along a wall or within a suitable architectural recess. Air enters through the lower intake, passes through the filter and heat exchanger, and is discharged upward into the occupied space. This arrangement supports steady room circulation in apartments, hotel rooms, offices, clinics and commercial interiors.
The range includes Midea MKH2-150-R4, MKH2-250-R4, MKH2-350-R4, MKH2-500-R4, MKH2-700-R4 and MKH2-800-R4 models. Depending on the selected size, high-speed airflow extends from 255 to 1300 m³/h. Published cooling capacities cover approximately 2.25–8.25 kW, while heating capacities range from 2.35 to 8.50 kW. The R4 designation identifies the four-row heat exchanger configuration. Actual capacity will vary with fan speed, entering air conditions, water temperature and water flow rate.
These units operate on a two-pipe hydronic circuit. The same coil is used for cooling or heating according to the seasonal water temperature supplied by the central system. A floor-standing fan coil is therefore not a self-contained refrigerant split air conditioner and does not connect directly to a refrigerant circuit. It requires a chiller, reversible heat pump or another suitable chilled- and hot-water source.
Correct selection should be based on the calculated room load rather than floor area alone. Airflow, acoustic requirements, entering and leaving water temperatures, hydraulic resistance, pipe sizing, thermostat control and available installation space must be considered together. The water circuit uses G3/4 connections, while the condensate line must be installed with reliable drainage and thermal insulation where required. Electrical and control connections should follow the manufacturer’s wiring documentation.
Regular maintenance keeps airflow and heat transfer within the intended operating range. The return-air filter should be inspected routinely and cleaned more frequently in dusty environments. Periodic servicing should also cover the heat exchanger, condensate tray, drain line and water connections. For additional installation formats and capacity options, visit the Fan Coil Systems section or browse the wider Cooling and Ventilation Systems range.
